T-shirt printing is a good hobby and a rewarding one. I remember when i was in college, i sell t-shirt that my brother made. The price is around 250 per shirt and the cost to produce is around 110-150 pesos. Not bad isn’t it. So, below is a simple tutorial about this. For sure, this would be a trial and error type of business but once you master it, money will surely come.
Silkscreen with frame.
Mixing bowl / cup
Squeegee applicator / rubber applicator
Plywood / hard flat plastic/Formica
Glass as big as the frame (optional)
Pressurized water source
- Think of a design. For starters, start with one color design. You could try the “worst president logo”. It is difficult to copy it by hand so better use a computer. Print it in an acetate. Because of the advent of computers using stencils is now a bit outdated.
- Clean the surface of the silkscreen. Be sure there is no dust, particles etc.
- Then get the photo emulsion. Usually it has two components. The pink liquid part and a white crystalline part or a clear liquid. Just mixed a minimal amount in the mixing bowl or cup. Enough to cover the whole silkscreen.(see instruction of manufacturer before using it, just to be sure.)
- Place the silkscreen vertically, slightly inclined, and the flat surface facing you.
- Now, use the paintbrush to apply thin layer of the photo emulsion to the screen. Apply it from the top going down. Be sure that all areas are covered and there is no bubbles or excess photo emulsion that is dripping. Do this also in the inner portion of the silkscreen.
- Upon doing so, place the silkscreen on a dark room or dark closet for at least 2-3 hours.
- Afterwards, place the acetate on the flat surface of the silkscreen and cover it will the glass. The acetate will be sandwich between the glass and the silkscreen. Then put it under the sun. Some uses a halogen lamp. They place it under the halogen lamp to dry. Exposure time would be from around 10-15 seconds using a halogen lamp. If under the sun it would depend on the intensity of the sun. In short, it would be a trial and error process.
- After sun drying / bulb drying, you need to remove the excess photo emulsion from the silkscreen. Use a pressurized water source to remove it. Spray into the silkscreen. You will see the image of the acetate is now in your silkscreen.
- Clean it thoroughly and let it dry.